特点对比
Char.
|
本厂产品
Our products
|
碳纤维
编织成型
Amount of
carbon fiber
used
|
可一次性编织宽度达600mm的加热垫,产品发热均匀,外观平整美观大方。
●Weaving widths up to 600mm can be a one-time heating pad, the product even
heating, the appearance of smooth appearance.
|
碳纤维加热垫
电极带
Carbon fiber
heating pad
electrode tape
|
采用编织电极带,使其与碳纤维丝接触性好增加加热垫的使用寿命
●Woven belt with electrodes so that good contact with the carbon fiber shaft to
increase the service life of heating pad
|
压接工艺
Press-fit
technoloty
|
压接工艺连接导线,增加可靠性
●Special copper-belt equipments,instead of normal soldering technology,
are used more reliable
|
粘接胶
Adhesive glue
|
采用专用点胶机点胶
采用专用耐高低温的热熔胶
符合汽车行业QC/T413标准的要求
●Special high/low temperature resistant glue is used,special equipments are
used to glue
●Conformance with automobile industry QC/T413 standard
|
线束
Sleeves of
conductors
|
线束采用自产的PVC管,电线采用德标及日标线具有可靠的环保性
●Harness with self-produced PVC pipe, wire and using German standard
and reliable marking on environmental protection
|
压力传感器
Thin film pressure
sensor of human
body
|
在施工座椅大于25kg压力时接通加热电路,否则即使加热开关打开加热垫也
不会工作,从而避免无人乘坐时误接通开关造成能源浪费和安全隐患。
压力传感器的使用寿命为100万次,工作温度-40℃~120℃。
所有产品均可配置此功能
●Function:the circuit is completed only if the sensor is under the pressures
of over 25kg(55 Ib),no matter the swith is on or off,to avoid the pad idle
heating when nobody on the seat and safety peril.
●The life time of the pressure senor,over 1 millon times,the working temperature:
-40℃(-40 F) ~120℃(248 F)
●With autonomous intellectual proerty right
●All products can be installed with such function
|
开关
Swithes
|
采用5档内置电路式加热开关,该开关具有传感器短路/断路/过压保护,及延时开通功能。
●5 files using built-in heating circuit switch, the switch has a sensor short / open circuit /
over-voltage protection, and delay opening feature.
|
双面胶
Double-coated
adhesive tape
|
双面胶采用德国优质双面胶带,粘接性更强
●The advanced special glue equipment is used.These are 10mm of two edges of the
backing uncoated adhesive,so that the backing is easily ripped open and installation
time is reduced.
|